Installation Guide

Place the house sign against the wall. Using a marker, mark the wall through the holes on the sign. Make sure the markings are vertically aligned and centered. There should be a total of 4 holes.

Drill holes using a 5.5 mm drill bit. Then insert the wall plugs into each of the 4 holes.

Insert the screws through the four stainless steel stand-offs and fix them into the wall plugs.

Take the screws from the stainless steel stand-offs and pass them through, in order: rubber washer → acrylic sign → rubber washer. Then screw them into the base of the stainless steel stand-offs.

Tip: If you are unable to tighten them at this stage, it may be because the hole markings in Step 1 were not precise. Try slightly loosening the screws from Step 3 to allow some adjustment space for the stand-offs.